Honeywell TH2110DV Installation Manual page 2

Installation Guide
Wallplate installation
Pull at bottom to remove thermostat from
wallplate.
Drill 3/16" holes for drywall. Drill 7/32" holes for plaster.
Wire hole
Wall anchors
CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power before beginning
installation.
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not place
the old control in the trash. Contact the Thermostat Recycling Corporation at
www.thermostat-recycle.org or 800-238-8192 for information on how and where to properly
and safely dispose of your old thermostat.
69-2800EFS—01
Remove the wallplate from the thermostat
as shown at left, then follow directions
below for mounting.
1. Pull wires through wire hole.
2. Position wallplate on wall, level and mark hole
3. Drill holes at marked positions as shown below,
4. Place wallplate over anchors, insert and tighten
M34683
positions with pencil.
then tap in supplied wall anchors.
mounting screws.
NOT
USED
R
C
AUX/
E
Y
C IS OPTIONAL
WITH BATTERIES
G
O
B
M34682
2
Mounting screws