NETGEAR N150 DGN1000v3 User Manual page 10

N150 Wireless ADSL2+ Modem Router DGN1000v3
The following table describes the buttons and LEDs on the front panel.
Table 1. Front panel buttons and LEDs
Button LED Description
WPS Pressing the WPS button lets you use Wi-Fi Protected Setup (WPS) to join the
network (see
following behavior:
•
•
•
WiFi Pressing the WiFi button turns the wireless radio in the modem router on or off. By
default, WiFi is on. The WiFi LED has the following behavior:
•
•
•
Internet •
•
•
•
DSL •
•
•
•
LAN (1–4)
•
•
Power •
•
•
•
Wi-Fi Protected Setup Method
Solid green. Wireless security has been enabled.
Blinking green. A WPS-capable device is connecting to the device.
Off. WPS is not enabled.
Solid green. There is WiFi connectivity.
Blinking green. Data is being transmitted or received over the WiFi link.
Off. There is no WiFi connectivity. You can still plug an Ethernet cable into one of
the LAN ports to get wired connectivity. For more information about the use of this
button, see Advanced Wireless Settings
Solid green. You have an Internet connection. If the connection timed out based
on the setting you entered on the Internet Setup screen, but the DSL connection
is still present, the LED stays green. If the Internet connection is dropped for any
other reason, the LED turns off.
Solid red. The Internet (IP) connection failed. For troubleshooting information,
see Troubleshoot the Internet Connection
Blinking green. Data is being transmitted over the DSL port.
Off. No Internet connection is detected or the device is in bridge mode (an
external device handles the ISP connection).
Solid green. You have a DSL connection. In technical terms, the DSL port is
synchronized with an ISP's network-access device.
Blinking green. The modem router is negotiating the best possible speed on the
DSL line.
Solid red. The DSL connection is not established.
Off. The unit is off or there is no DSL link established.
Solid green. The LAN port has detected an Ethernet link with a device.
Off. No link is detected on this port.
Solid green. Power is supplied to the modem router.
Solid red. The modem router performs a power-on self-test (POST) when it
starts. After about one minute, the Power LED turns solid green. If the Power LED
remains red or lights red at any other time, a device malfunction has occurred.
Off. Power is not supplied to the modem router.
Blinking red. When the Restore Factory Settings button is pressed for seven
seconds (pressing it briefly only resets the unit), the Power LED blinks red three
times and then turns green as the modem router resets to the factory defaults.
Hardware Setup
10
on page 21). The WPS LED has the
on page 91.
on page 136.