CONTENTS INTRODUCTION..........................WARNINGS and CAUTIONS ......................3 - 4 CONTROL LOCATION ........................INPUT and OUTPUT ......................... OPERATION INSTRUCTIONS ......................7-10 LOCATION OF CONTROL(REMOTE CONTROL UNIT) ..............11-13 BATTERY INSTALLATION......................... SERVICE TIPS ..........................
INTRODUCTION Thank you for purchasing this television. To get the most out of this unit please carefully read the instructions and keep them in a safe place for future reference. INSTALLATION Locate the receiver in the room where direct light does not strike the screen. Total darkness or a reflection on the picture screen can cause eyestrain.
WARNINGS and CAUTIONS Warning High voltages are used in the operation of this television receiver. Do not remove the cabinet back from your set. Refer servicing to qualified service personnel. Warning To prevent fire or electrical shock hazard , do not expose the television receiver to rain or moisture.
Page 6
WARNINGS and CAUTIONS Caution Never stand on, lean on or push suddenly the television or its stand .You should pay special attention to children. Serious injury may result if it should fall. Caution Do not place your television on an unstable cart , stand , shelf or table .Serious injury to an individual , and damage to the television, may result if it should fall.
CONTROL LOCATION 1. Main Switch 2. Remote Sensor 3. Power Indicator 4. Program Down/Up Button 5. Volume Down / Up Button 6. Menu Button AV/TV Button 8. Speakers 9. Side AV In 10. YUV(Y, Cb, Cr) In 11. S-Video In 12.
INPUT AND OUTPUT TERMINALS YUV IN AV IN 1 AV OUT VIDEO AUDIO AUDIO LEFT RIGHT 75 ANT S-VIDEO LEFT LEFT RIGHT RIGHT It can be connected to the following appliances: video-tape recorder, video camera, tape recorder and audio amplifier, etc..*Please keep AC cord unplugged when connecting TV system.
OPERATION INSTRUCTIONS WARNING: The main power switch ( No.1 of the control location page ) is the manually operated mechanical switc . The remote control can not cut off power supply to the TV set. For safety purpose, push main switch to the OFF position and make sure the power indicator goes out when not use for long time.
Page 10
OPERATION INSTRUCTIONS TIMERS 1.CLOCK Select hour or minute with PROG+/- buttons or (GREEN) / (BLUE) buttons TIME Adjust CLOCK time with VOL+/- buttons or (RED) / (YELLOW) buttons CLOCK --:-- You can press CLOCK buttons to display currently clock time. ON TIME --:-- ON PROG...
Page 11
OPERATION INSTRUCTIONS SETUP Button You can select the item by pressing PROG+/- buttons or (GREEN)/ (BLUE) Buttons. then you can adjust it by Vol+/- buttons or (RED)/(YELLOW) buttons. SETUP 1.LANGUAGE LANG. ENGLISH You can select the on-screen display language. BACK GROUND NOISE REDUCE CHILD LOCK 2.BACK GROUND...
OPERATION INSTRUCTIONS TUNE MENU You can select the item by press the PROG+/- buttons or the (GREEN) / (BLUE) buttons, move to the menu you select and then do as follows. TUNE 1.COLOUR SYS CONLOUR SYS AUTO Press VOL+/- buttons or (RED) / (YELLOW) buttons to set the colour SOUND SYS BAND VHF-L...
LOCATION OF CONTROL (REMOTE HANDSET UNIT) STAND BY BUTTON ( Press this button to turn the TV on/off. Press any Number Button or Program Up/Down Button, picture and sound will appear on within a few seconds. SLEEP BUTTON( This key is used to set the sleep timer from in 10 minutes step up to three hours.
Page 14
LOCATION OF CONTROL (REMOTE HANDSET UNIT) VOLUME UP/DOWN BUTTONS (VOL.+/-) Press Volume Up/Down Buttons to adjust sound level. PROGRAM SELECTION BUTTONS(0-9) Push the number for your desired program and the program indicator will be displayed on the screen. Press number key 0-199 for program selection. MUTE BUTTON( Press once to mute the sound, press again to return to previously set sound level.
Page 15
LOCATION OF CONTROL (REMOTE HANDSET UNIT) SOUND MENU BUTTON(SOUND/ RECALL) In TV mode, used as SOUND menu command. SOUND: Press this button to enter into the SOUND menu directly. RECALL :Sometimes the answers of quizes, jokes etc are hidden. Press REVEAL button to reveal the hidden information.
BATTERY INSTALLATION (REMOTE CONTROL UNIT) 1. Remove the battery cover. 2. Insert the 2 UM4-AAA 1.5V batteries making sure the polarity (+ or -) of the batteries matches the polarity marks inside the unit. 3. Replace the battery cover. Replace with new batteries when the TV set begins to show the following symptoms: Operation is unsteady or erratic.
SERVICE TIPS BEFORE CALLING FOR SERVICE, HAVE YOU CHECKED ( ) THE FOLLOWING CHART ON SYMPTOMS AND SOLUTIONS? Symptoms No picture, no sound Poor sound, picture OK Poor picture, sound OK Weak picture Blurred picture Double image Lines in picture Distorted picture Weak reception on some channels Horizontal bars...