Preparations - Sony DCR-TRV9 Service Manual

1-1-2.

Preparations

Note 1: For details of how remove the cabinet and boards, refer to "2.
DISASSEMBLY".
Note 2: When performing only the adjustments, the lens block and boards
need not be disassembled.
1) Connect the equipment for adjustments according to Fig. 5-1-
2.
2) The front panel block (MA-322 board, focus ring, microphone
unit) must be assembled because the focus ring is used for
manual focusing.
Note 3: As removing the cabinet (R) (removing the VC-206 board CN9912)
means removing the lithium 3V power supply (LI-64 board) , data
such as date, time, user-set menus will be lost. After completing
adjustments, reset these data. If the cabinet (R) has been removed,
the self-diagnosis data, data on history of use (total drum rotation
time etc. ) will be lost. Before removing, note down the self-
diagnosis data and the data on history use (data of page: 2, address:
35 to 3D). (Refer to the "Service Mode" for the data on the history
use.)
Note 4: Setting the "Forced Camera Power ON" Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01, and press the PAUSE
button of the adjustment remote commander. The above
procedure will enable the camera power to be turned on with
the power switch block (PS-4580) removed. After completing
adjustments, be sure to exit the "Forced Camera Power ON
Mode".
Note 5: Exiting the "Forced Camera Power ON" Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 00, and press the PAUSE
button of the adjustment remote commander.
3) Select page: 0, address: 01, and set data: 00.
Pattern box
Front of the lens
5-2
1.5m
Fig. 5-1-2.