Pre-Configured Models - HP ProLiant DL360e Specification

QuickSpecs

Pre-configured Models

NOTE: For the Standard Features shipped in the "Factory Integrated Models", please see the "Configuration Information - Factory
Integrated Models" section.
NOTE: Pre-configured models ship with the configurations below. Options can be selected from the Core or Additional options section
of this QuickSpecs.
NOTE: HP does not allow factory integration of options into pre-configured models. Any additional options purchased will be shipped
separately.
NOTE: If you desire a custom configuration please see "Configuration Information - Factory Integrated Models" section of this
QuickSpecs.
NOTE: All Pre-configured Models come populated with some hard drive blanks installed. Should the customer need additional hard
drive blanks, they can order more using either P/N 666987-B21: HP SFF Gen8 Hard Drive Blank Kit or P/N 666986-B21: HP LFF Gen8
Hard Drive Blank Kit.
NOTE: When the SAS FIO riser kit (PN 661387-B21) which includes HP Dynamic Smart Array B320i controller is installed in the server,
the embedded Smart Array B120i controller is automatically disabled. In the absence of another storage controller or an expander
backplane, drives operate in ACHI or Legacy mode. In these two modes, the drives are not part of a hardware RAID or a member of a
logical drive. The Locate, Drive status, and Do not remove LEDs in the drive carrier are disabled.
NOTE: Not all models are available in all regions. Check with your local country HP offices for availability.
Entry Models - SAS
HP ProLiant DL360e Gen8
E5-2403 1P 4GB-R Hot
Plug 8 SFF 460W PS Entry
Server
668813-xx1
Processor(s)
Cache Memory
Memory
Network Controller
Storage Controller
Hard Drive
Internal Storage
Optical Drive Bay
PCI-Express Slots
Power Supply
Fans
Management
Form Factor
Warranty
DA - 14327 Worldwide — Version 33 — December 16, 2013
HP ProLiant DL360e Generation 8 (Gen8)
(1) Intel® Xeon® E5-2403 (1.8GHz/4-core/10MB/80W, DDR3-1066) Processor
10MB (1x10MB) Level 3
4GB (1 x 4GB) Registered DIMMs PC3L-10600R (1333MHz)
NOTE: Memory runs at 1066MHz speed due to processor.
HP Ethernet 1Gb 4-port 366i Adapter
HP Dynamic Smart Array B320i Controller
NOTE: Provides support for up to 8 SAS or SATA drives and includes SAS
license key (PN BC393A).
None ship standard; includes 7 SFF hard drive blanks
8 SFF HDD Bays
1; (Optional: DVD-ROM, DVD-RW)
2 standard (1-FH/HL (250mm), 1-LP)
(1) HP 460W CS Gold Hot Plug Power Supply (92% Efficient)
4 Hot-Plug Non-redundant Fans
HP iLO Management Engine (standard)
Optional: HP iLO Essentials or HP Insight Control
Rack (1U)
NOTE: Includes Rack Mounting Gen8 non-telescoping Friction Rail Kit which
does not allow for in rack serviceability. The HP 1U Gen8 Cable Management
Arm is not available when using Friction Rails. To assist in the installation of
the server into the rack an optional installation tool is available by contacting
your local services representative (p/n 695539-001). Caution: HP recommends
that a minimum of two people is required for all Rack Server installations.
Please refer to your installation instructions for proper tools and number of
people to use for any installation.
Server Warranty includes 3-Year Parts, 1-Year Labor, 1-Year Onsite support
with next business day response.
Page 17