HP Z800 Specification page 5

QuickSpecs
Overview
Humidity
Maximum Altitude (non-
pressurized)
Power Supply
Interfaces Supported
Hard Drive Controller
Supported
Backup Devices
Operating:
Non-operating
Operating:
Non-operating
Choice of:
850W 85% Efficient wide-ranging, active Power Factor Correction
1110W 89% Efficient wide-ranging, active Power Factor Correction
NOTE: The 1110W power supply can also supply 1250W of output power when the input voltage is greater
than 105V. If the input voltage is less than 105V, but greater than 90V for any reason, the maximum power
that can be drawn is 1110W. An uninterruptible power supply (UPS) is highly recommended if 1250W
output power is desired.
The Z800 power supply efficiency reports can be found at these links:
850W - http://www.plugloadsolutions.com/psu_reports/DELTA_DPS-850DB%20A_850W_80+_Report.pdf
1110W - http://www.plugloadsolutions.com/psu_reports/DELTA_DPS-1050DBA_SO-
035_1250W_Report.pdf
6-channel SATA 3.0 Gb/s Interface (6 Serial-ATA connectors on the motherboard, 4 channels are
eSATA configurable for use with eSATA CTO/AMO Kit)
8-channel SAS interface (8 SAS connectors on the motherboard), SAS ports can be ported externally
by using the SAS Bulkhead and/or Back Panel connector Kits
1 Floppy interface (1 Floppy connector), IEEE 1394a, USB 2.0
SATA and SAS controllers
For a complete listing of compatible DAT tape drives, LTO tape drives and RDX Removable Disk Backup
System offerings, please visit:
DA - 13278 North America — Version 56 — November 21, 2013
8% to 85%
8% to 90%
3,000 m; 10,000 feet
9,100 m; 30,000 feet
http://www.hp.com/go/connect
HP Z800 Workstation
Page 5