Memory Configurations - HP ProOne 600 G1 Specification

Hp proone 600 g1 all-in-one business pc

Hardware reference manual (59 pages)

Table of Contents

QuickSpecs

Technical Specifications – Memory

System Memory Support

The HP ProOne 600 G1 All-in-One Business PC supports the 4th generation Intel® Core™ processor families. Based on a new PC micro-

architecture, the processor is designed for a two-chip platform consisting of a processor and Platform Controller Hub (PCH). Unlike

previous generations, the processor includes an integrated memory controller (IMC). The IMC supports DDR3 protocols with two

independent, 64-bit wide channels each accessing one SODIMM.

Two channels of non-ECC DDR3 unbuffered small outline dual in-line memory modules (SODIMM) with a maximum of one DIMM

per channel

Single-channel and dual-channel memory organization modes

Data burst length of eight for all memory organization modes

DDR3 memory data transfer rates of up to 1600 MT/s; actual supported DDR3 data transfer rate determined by the configured

processor

64-bit wide channels

DDR3 system memory I/O voltage of 1.5V and 1.35V

Theoretical Maximum Memory Bandwidth:

10.6 GB/s in single-channel mode of 21.3 GB/s in dual-channel mode assuming DDR3 1333 MT/s

12.8 GB/s in single-channel mode or 25.6 GB/s in dual-channel mode assuming DDR3 1600 MT/s

16 GB maximum memory support

CAUTION: You must shut down the computer and disconnect the power cord before adding or removing memory modules. Regardless

of the power-on state, voltage is always supplied to the memory modules as long as the computer is plugged in to an active AC outlet.

Adding or removing memory modules while voltage is present may cause irreparable damage to the memory modules or system board.