Panasonic TH-85PF12U Operating Instructions Manual page 57

Item
Off:
Studio W/B On:
Note: Valid only when the "WARM" is set as "COLOR TEMP" in PICTURE menu.
Sharpens the contrast for a better view when a part of the image is too light to see.
Off:
Studio Gain On:
Note: This setting is valid only when the input signals are as follows:
Off
Off:
Auto: Power is transmitted to the slot power only when main power is on.
Slot Power
On:
Note: In some cases, power is transmitted to the slot power when main power is on or in the standby state
Off
You can set the power-on delay time of the displays to reduce the power load, when you press
on the multiple displays that are set together, for example, on MULTI DISPLAY system.
Set each display's setting individually.
Off:
1 to 30 (sec.): Set the power-on delay time (second).
Power On Screen
Notes:
Delay
• During this function is working, the power indicator is blinking green.
• This function also works when the power recovers from failure or after plugging off and in again the power cord.
After you unplug and plug the power cord in while the unit is in standby mode and also the power is being
supplied to a terminal board, the unit will start supplying the power to the board with time delay according
to the setting.
The power indicator lights up red fi rst and it turns orange when the power starts being supplied to the board.
Off:
On:
The clock is displayed at the lower left of the screen when
Clock Display
Sets All Aspect mode (advanced aspect setting) or default aspect mode.
With each press of
Off:
On:
All Aspect
Aspect mode of each setting is as follows:
(Example: HD signal)
Off
On
Sets the operational mode of the automatic position adjustment in the POS./SIZE menu.
Manual: Automatic position adjustment starts when
Auto Setup
Auto:
Off:
Rotate
On:
Slot1
Serial Slot
Selects the slot which communicates serial.
Select
Note: The setting of an external command can be set only from the fi xed serial terminal. (see page 11)
Normalization
When both main unit buttons and remote control are disabled due to the "Button lock", "Remocon User level" or "Remote
ID" adjustments, set all the values "Off" so that all the buttons are enabled again.
Press the button on main unit together with
-
/
"Shipping" menu is displayed and the lock is released when it disappears.
Nullify all the settings adjusted.
Sets the color temperature for TV studio.
Disables "Studio Gain".
Enables "Studio Gain".
Component Video, RGB (analog), SDI, HDMI
Auto On
Power is not transmitted to the slot power.
Power is transmitted to the slot power when main power is on or in the standby state.
regardless of the slot power setting.
1 2 3.... 30
The display will be turned on at the same time as
After pressing , the display will be powered on with time delay depending on this setting.
Not display the clock.
Display the clock.
Note: When "PRESENT TIME SETUP" is not set, the clock is not displayed even
if "Clock Display" is "On" (see page 36)
10:00
button, the aspect changes in the selected mode.
Default aspect mode
All Aspect mode
4:3→H-FILL→ZOOM→FULL→JUST
4:3 (1)→4:3 (2)→4:3 Full→Zoom1→Zoom2→Zoom3→16:9→14:9→Just1→Just2
adjustment is executed from the POS./SIZE menu.
Other than remote control or menu operation, automatic position adjustment starts:
When the display power is turned ON.
When the input signal is switched.
Does not rotate the image.
Rotates the image 180 degrees.
Slot2 Slot3
button on the remote control and hold for more than 5 seconds. The
Options Adjustments
Adjustments
is pressed.
button is pressed.
is pressed on the remote control or automatic position
to turn
57