Selecting The Input Signal - Panasonic TH-85PF12U Operating Instructions Manual

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed into the SLOT.
• Select to match the signals from the source connected to the component/RGB input terminals.
(see page 50)
• In 2 screen display, the same input mode cannot be selected for the main picture and sub
picture.
• Image retention (image lag) may occur on the plasma display panel when a still picture is kept
on the panel for an extended period. The function that darkens the screen slightly is activated
to prevent image retention (see page 60), but this function is not the perfect solution to image
retention.
Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1 INPUT2A
SLOT2 is for dual input so that you can select INPUT2A or
INPUT2B for INPUT2.
INPUT2A : HDMI signal terminal in SLOT2
INPUT2B : HDMI signal terminal in SLOT2
Press the INPUT "1", "2", "3" or "PC"
input mode selection button to select
the INPUT mode.
Press to switch the input mode
between INPUT2A and INPUT2B.
INPUT2B INPUT3 PC
ENTER /
+
/
VOL
-
/
MENU
INPUT
15