Pyle PHPW2 User Manual

User Manual of Wireless Earphone
"AUDIO
our"
socket of
TVfor DVD, VeO)
Computer&CDplayeraudloo
utputearphon••ocket
Tranllmltteraudlo input socket
1, Installation
InsJaliation of receiver (Figure A)
Open battery case cover and place in two No.7 batteries
Installation of transmitter (Figure B)
Connect transformer correctly (connect 3V transformer restJectively to power supply and transmitter;
place in two No.7 batteries instead when not using transformer for power supply).
Plug lotus jack into "AUDIO OUT" socket of transmitter lTV (or DVO, VCD)
(Note: TV, DVD, VCD uses lotus plug)
A,dlolnp,'ooo'.tfo".ft
Stereo plug should be respectively inserted into transmitter's audio
&"gh'ch.nn.lto""n.mltl.,
input socket and audio output earphone -,. . . . .
'iii'
socket of computer or CD player.
(Note: volume of received sound is also determined by volume of computer or CD player)
2, Operation instructions
1)Turn power switch upward to activate transmitter; the power light should be turned on.
2)Pull up receiver's antenna, turn receiver's power switch upward and volume tuner to your desired position;
the power light should be turned on.
3)Press RESET button and SELECT button to receive TV sound. (NotE!: the first sound received is from TV,
and then FM radio, computerlDVD and similar products.)
3, Radio receiving
1)Receiver can be used as FM radio receiver when used alone.
2)Turn upward to turn on receiver's volume control, the power light should be turned on and pull up receiver's
antenna.
3)Press RESET and then digital SELECT to automatically scan FM radio between 88MHz to 108MHz; one
radio station will be scanned and locked for each time SELECT button is pressed.
Plug In audio output socket on comput.r
Power switch
Power indicator Iight(front)
B. Transmitter
3, Stereo jack for audio input
Stereo jack Is plugged In to earphone or audio output
socket of computer, CD, tape recorder etc.
4, Lotus line left & right sound channel
socketLotus plug is inserted left & right
sound output channel of
TV, DVD,
and
VCD.
Note: this product can be used as wired earphone
when connected with audio line.
4, Using wired earphone
Receiver is supplied with an audio wire to use as a wired earphone.
Cautions:
If sound is too loud or distorted, please turn down source volume (TV or other products) to improve receiving effect.
Replace batteries when the following problems occur:
Power light is dim.
Receiver can barely receive sound.
Sound volume is low and distorted.
Turn off transmitter's power supply after usage. (It is suggested to place transmitter at high position for better
signal receiving.)
A Receiver
..
~(j).
Antenna
Appearance and functions ~~~~%:~~~ce~
and
@RESET
@.Power light indicator
~
(5).SELECT
_~~_-----"III""" @Battery case
C1>.Audio line socket