General; Introduction; Terminology; Deviations From Standard - Hitachi HTS542525K9SA00 Specifications

8.0 General

8.1 Introduction

This specification describes the host interface of the HDS7216xx0PLATy0 hard disk drive.
The interface conforms to the Working Document of Information technology, AT Attachment with Packet Interface
Extension (ATA/ATAPI-7) Revision 4, dated 23 December 2003, with certain limitations described in Section 8.3
below.

8.2 Terminology

Device
Host

8.3 Deviations from standard

The device conforms to the referenced specifications with the following deviations:
Check Power Mode
Hard Reset
Download
Streaming Commands
Error Recovery Control SCT Command set)
Device indicates HDS7216x0PLATy0
Host indicates the system that the device is attached to
Check Power Mode command returns FFh to Sector Count Register when
the device is in Idle mode. This command does not support 80h as the
return value.
Hard reset response is not the same as that of power on reset. Refer to
section 7.1, "Reset response" on page 55 for details.
Download command is aborted when teh device is in security locked
mode.
When the device is in standby mode,Streaming Commands can't be
completed while waiting for the spindle to reach operating speed even if
execution time exceeds specified CCTL(Command Completion Time
Limit). The minimum CCTL is 50ms.CCTL is set to 50ms when the
specified value is shorter than 50ms.
When the device is in standby mode,any command where error recovery
time limit is specified can't be completed while waiting for the spindle to
reach operating speed even if execution time exceeds specified recovery
time limit.The minimum time limit is 6.5 second.When the specified time
limit is shorter than 6.5 second,the issued command is aborted.
Deskstar 7K160 Hard Disk Drive Specification
65