Connecting Using Hdmi - Pioneer DVR-560HX-K Operating Instructions Manual

Connections
AUDIO VIDEO
R L
ANTENNA
IN
S-VIDEO
INPUT 3
AV 2 (INPUT 1/DECODER)
G-LINK
IN
OUT
P CONTROL
Y B P R
AV 1 (RGB) – TV
COMPONENT VIDEO OUT OUTPUT
AUDIO/VIDEO
OUTPUT
3
To audio/
video input
AV amp/
receiver
TV
1 Connect your TV antenna to the
recorder and TV.
See Connecting a TV antenna on page 15 for
details.
This enables you to watch and record TV
channels.
2 Connect the DIGITAL AUDIO OUT
(COAXIAL) jack on this recorder to a
coaxial digital input on your AV
amplifier/receiver.
This enables you to listen to multichannel
surround sound.
3 Connect the analog AUDIO OUTPUT
and VIDEO OUTPUT jacks on this recorder
to an analog audio and video input on
your AV amplifier/receiver.
4 Connect the AV amplifier/receiver's
video output to a video input on your TV.
Note
1 Depending on the component you have connected, using a DVI connection may result in unreliable signal
transfers.
2 The pixel resolution of this recorder's HDMI video output is (according to TV format): NTSC (720 x 480i/p,
1280 x 720p, 1920 x 1080i/p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i/p). If your display is not compatible
with these resolutions the picture may not be correctly reproduced.
3 The 1080p video may not be displayed correctly if the High Speed HDMI cable is not used.
COAXIAL
AC IN
DIGITAL OUT
HDMI OUT
5 V 30 mA
IN OUT
ANTENNA(DIGITAL)
DIGITAL
AUDIO OUT
2
To digital input
From video
output
4
To video input

Connecting using HDMI

If you have an HDMI or DVI-equipped
2
monitor or display , you can connect it to
this recorder using an HDMI cable
supplied).
The HDMI connector outputs uncompressed
digital video, as well as almost every kind of
digital audio.
1 Use an HDMI cable to connect the
HDMI OUT connector on this recorder to
an HDMI connector on an
HDMI-compatible display.
To HDMI
HDMI
input
IN
HDMI-compatible display
HDMI
OUT
AUDIO VIDEO
R L
ANTENNA
IN
S-VIDEO
INPUT 3
AV 2 (INPUT 1/DECODER)
G-LINK
IN IN
OUT
Y P P CONTROL
B R
AV 1 (RGB) – TV
COMPONENT VIDEO OUT OUTPUT
• The arrow on the cable connector body
should be face down for correct
alignment with the connector on the
recorder.
When connected to an HDMI component or
HDCP-compatible DVI component, the
HDMI indicator lights.
HDMI setup is generally automatic. There
are however settings you can change if you
need to. See HDMI Output (only available
when an HDMI device is connected) on
page 144 for more information. Note that the
HDMI settings remain in effect until you
1
3
(not
COAXIAL
AC IN
DIGITAL OUT
HDMI OUT
5 V 30 mA
OUT
ANTENNA(DIGITAL)
02
21
En