Cisco Aironet 1550 Series Getting Started Manual page 36

Access Point
Cisco Aironet 1300 Series
Cisco Aironet 1500 Series
Cisco Aironet 1520 Series
Cisco Aironet 1550 Series
1. For controller release 4.1 or later.
2. For controller release 4.0, the VCI depends on the model.
3. For controller release 3.2.
The format of the TLV block for 1100, 1130, 1200, 1240, 1250, 1300, 1520, and 1552 access points
are listed below:
• Type: 0xf1 (decimal 241)
• Length: Number of controller IP addresses * 4
• Value: List of WLC management interfaces
Configuring Option 43 for Cisco 1000, 1500, and 1550 Series Access Points
To configure DHCP Option 43 for Cisco 1000, 1500, and 1550 series access points in the embedded Cisco
IOS DHCP server, follow these steps:
Enter configuration mode at the Cisco IOS CLI.
Step 1
Create the DHCP pool, including the necessary parameters such as default router and name server.
Step 2
The commands used to create a DHCP pool are as follows:
ip dhcp pool pool name
network IP Network Netmask
default-router Default router
dns-server DNS Server
Where:
pool name is the name of the DHCP pool, such as AP1000.
IP Network is the network IP address where the controller resides, such as
10.0.15.1
Netmask is the subnet mask, such as 255.255.255.0
Default router is the IP address of the default router, such as 10.0.0.1
DNS Server is the IP address of the DNS server, such as 10.0.10.2
Vendor Class Identifier (VCI)
Cisco AP c1300
1
Cisco AP c1500
Cisco AP.OAP1500
2
Cisco AP.LAP1505
3
Airespace.AP1200
Cisco AP c1520
Cisco AP c1550
2
, Cisco AP.LAP1510
2
, or