Using The Clock And Timer - GE JBP83 Owner's Manual

Using the clock and timer.

Make sure the clock is set to the
correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting on
the timer is 9 hours and 59 minutes.
14
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle. You cannot
change the clock time while an automatic
oven function is programmed.
To Set the Timer
Press the TIMER/CLOCK pad.
Press the + and – pads until the
amount of time you want shows
in the display. Maximum time that
can be entered in minutes is 59.
Cooking times more than 59
minutes should be changed to
hours and minutes. For example,
enter 90 minutes as 1 hour,
30 minutes.
If you make a mistake, press the
TIMER/CLOCK pad and begin again.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by pressing
the TIMER/CLOCK pad, then press the +
and – pads until the time you want
appears in the display.
To Cancel the Timer
Press the TIMER/CLOCK pad twice.
Power Outage
If a flashing time is in the display, you have
experienced a power failure. Reset the clock.
Press and hold the TIMER/CLOCK
pad.
Press the + and – pads.
Press the START pad.
To check the time of day when the display is
showing other information, simply press the
TIMER/CLOCK pad. The time of day shows
until another pad is pressed.
Press the START pad.
When the timer reaches :00, the
control will beep 3 times followed
by one beep every 6 seconds until
the TIMER/CLOCK pad is pressed.
The 6 second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
pressing the TIMER/CLOCK pad and then
pressing the + and – pads until the time
you want appears in the display.
To reset the clock, press and hold the
TIMER/CLOCK pad until the display
changes.
Enter the correct time of day by pressing
the + and – pads until the time you
want appears in the display. Press the
START pad.