Table of Contents
Advertisement
Section 1-2
1-2 Rear panel
RF Input socket: The IF output (10.7 MHz / 45.05 MHz) from a suitable receiver such as the
AR5000A should be connected to this BNC input socket using a 50 OHM patch lead constructed of
quality coaxial cable such as RG58/U, UR43, UR76 etc. A suitable BNC-BNC lead is supplied.
PC I/F socket (male): A controlling computer may be connected to this 9-pin D-type male socket.
Ensure this socket is only commented to a computer for hands-off operation, although it is very
unlikely that incorrect connection to a computer or similar device would cause damage.
RX connection socket (female): The supplied 9-way to 9-way 'D-type' male to male lead is used to
connect the SDU5600 to the AR5000A receiver. If used with another receiver, a suitable serial-
adapter or connecting cable will be required. Wiring should be as follows:
SDU5600 9-pin male
2
3
5
7
8
12V DC input socket: The supplied power unit is terminated with a centre positive (+) polarity.
The plug specification follows EIAJ RC-5320A (Class-4).
There are four screw holes (unused), two on each side of the cabinet.
They are a provision for rack mount application. Size of the screw is M4x8.
10
9-pin male (AR5000A) 25-pin male (AR3000A)
2
3
5
7
8
3
2
7 GND
4
5
Advertisement
Table of Contents
