Whistler GT-438G Owner's Manual page 10

Windshield Mounting
• Install the two suction cups and rubber bumper onto the bracket
by fitting them into their holes.
• Press the suction cups onto the windshield at the location you
have chosen.
Important: Some newer cars have a plastic safety coating on
the inside of the windshield. The windshield bracket may leave
permanent marks on this type of surface. To find out if your
vehicle has this type of windshield, check the vehicle's owner's
manual or ask your dealer. We recommend that you do not leave
the suction cup bracket on the window in direct sunlight. If the
detector is removed, this may cause blistering of the dash in
some vehicles.
• Slide the detector onto the bracket until it locks into place.
• If necessary, the unit may be leveled by bending the windshield
bracket. Press the bracket release button and remove the
detector before bending.
INSTALLATION
7
Rubber
Bumper