Listening To The Radio; Listening To Other Sources - Sanyo DTA-200 Instruction Manual

Automatic/Manual tuning
1. Press the TUNER/BAND button to select FM or AM.
- "TUNER" appears on the display, then "TUNER" is replaced by
the tuner mode display.
2. Automatic tuning
Press the + or – TUNING button for at least 1 second to tune in a
station. The unit will scan up or down the band and receive the next
receivable station. Press the button again to continue.
Manual tuning
Press + or – TUNING button briefly until the desired frequency is
displayed.
To preset stations
Up to 20 stations for FM band, 20 stations for AM band can be preset.
1. Tune in the station to be preset as described in "Automatic/Manual
tuning".
2. Press the MEMORY button.
3. Press the + or – PRESET button on the front panel (or the PRESET
button on the remote control) to select the channel number to be
preset.
4. Press the MEMORY button.
- In this example. "103.25 MHz" FM station is preset on FM chan-
nel 9.
Note:
If the MEMORY button is not pressed within 3 seconds, the station is
preset automatically.
1. Check the connections with the auxiliary equipment to perform AUX
IN or AUX OUT function.
2. Select "AUX" to the IN or OUT position (rear of the unit).
- If AUX IN position is selected, press the FUNCTION button to
select "AUX".

LISTENING TO THE RADIO

LISTENING TO OTHER SOURCES

5. Repeat the steps above to add more preset stations.
- When presetting a new station, the previously preset station is
cleared.
Listening to preset stations
1. Press the TUNER/BAND button to select FM or AM.
2. Press the + or – PRESET button on the front panel (or the PRESET
button on the remote control) to select the desired channel number.
The selected channel number appears briefly.
To receive FM stereo broadcasts
"ST" appears when an FM stereo broadcast is received. If not, press
the MODE button to turn the "ST" indication on. "STEREO" appears
briefly.
- If the signal from an FM stereo station is weak and reception is
poor, press the MODE button to change to the MONO mode.
"MONO" appears briefly. The reception may be improved, but the
sound will be monaural.
Changing the reception frequencies
If necessary, use the following procedure to change the reception
frequencies.
1. Select the band to be changed.
2. While pressing the n button, press the MEMORY button and the
TUNER/BAND button at the same time.
AM: 520 ~ 1710 kHz (10 kHz steps)
522 ~ 1611 kHz (9 kHz steps)
FM: 87.9 ~ 107.9 MHz (200 kHz steps)
87.5 ~ 108.0 MHz (50 kHz steps)
3. Follow the instructions provided with the auxiliary equipment.
-8-