Black & Decker LINEFINDER JS680V Instruction Manual page 8

Blade storage (figure E)
A blade storage compartment (11) is built-in to
the side of the saw.
To open the storage door:
- Grasp the tab at the top of the door and pull
outward.
The blades are held in place by a magnet.
- To release a blade, press down on one end
to raise the other for access.
CAUTION: Close door securely before
operating saw.
Switching on and off
- To switch the tool on, press the on/off switch
(1).
- For continuous operation, press the on/off
switch (1), press the lock-on button (2) and
release the on/off switch.
- To switch the tool off, release the on/
off switch. To switch the tool off, when in
continuous operation, press the on/off switch
once more and release it.
Operating the UV Module (figure f, G & h)
Installing the batteries (figure f)
- Pivot the UV module door (16) away from
the jig saw by removing the screw (17) and
pulling the door forward.
- Insert three new 1.5 Volt AAA alkaline
batteries (18), making sure to match the (+)
and (-) terminals correctly.
- Close the UV module door and replace the
screw.
Using the UV light (figure G & h)
The UV module projects a UV light which
illuminates a highlighter line drawn on the
surface of the workpiece.
To use the UV light:
- Mark your intended cutting line using the
highlighter marking pen (14) as shown in
figure G.
e
4
f
17
16
18
G
8
14
11