Black & Decker LINEFINDER JS680V Instruction Manual page 4

Caution: To reduce the risk of eye injury while using the UV light:
• Do not point UV light at bystanders.
• Turn off UV light when changing blade.
• Do not use UV light as a flash light.
• Do not stare into UV light
• Jig saw should not be used by any photo sensitive individual or any individual
who has been subjected to a photo sensitive agent. (eg. Like during eye exam)
• Use extra caution when cutting concave reflective work pieces to prevent
incidental UV light reflection towards your eyes or the eyes of bystanders.
wARNING: Some dust created by power sanding, sawing, grinding, drilling, and
other construction activities contains chemicals known to the State of California
to cause cancer, birth defects or other reproductive harm. Some examples of
these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
wARNING: Use of this tool can generate and/or disperse dust, which may cause
serious and permanent respiratory or other injury. Always use NIOSH/OSHA
approved respiratory protection appropriate for the dust exposure. Direct particles
away from face and body.
CAUTION: wear appropriate hearing protection during use. Under some
conditions and duration of use, noise from this product may contribute to hearing loss.
wARNING: ALwAyS use safety glasses. Everyday eye glasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty. ALwAyS
wEAR CERTIfIED SAfETy EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3)
• ANSI S12.6 (S3.19) hearing protection
• NIOSH/OSHA/MSHA respiratory protection
SyMBOLS
The label on your tool may include the following symbols.
V ........................... volts
Hz ......................... hertz
min ........................ minutes
...................... direct current
.......................... Class II Construction
.......................... safety alert symbol
A ......................... amperes
W ........................ watts
.......................alternating current
n o ....................... no load speed
........................ earthing terminal
.../min ..................revolutions or
4
reciprocations
per minute