Table of Contents
Advertisement
User Function 34 - Camera Indicator
User Function 35 - Controllable Cameras
User Function 36 - Select Crosspoint Data
User Function 37 - R/D Address Mode
User Function 38 - Printer Port Mode
User Function 39 - Select DIU Interface Port
User Function 40 - Reserved Function
User Function 41 - Set Satellite Communication Format
EN | 62
This function is used to enable an onscreen indicator to identify a pan/tilt
equipped camera. Move the joystick up or down to select DISP CAM
CONTROL or NO CAM CONTL DISPL. Press [Enter] to activate your
selection. When enabled, cameras identified as controllable (via User
Function 35 or the optional LTC 8059/00 MCS package), show a
in the middle of the first line of monitor text.
Priority 1 users can use this function to select camera sites equipped with pan/tilt
devices. Move the joystick up or down to select the camera number, and left or right
to select FIXED or MOVABLE. User Function 34 or the optional PC software pack-
age enables or disables the display of the controllable camera indicators on the sys-
tem monitor displays.
Use this function to select options for accessory device data that can be sent out the
biphase control port. Move the joystick up or down to select XPOINT DATA, ALARM
XPOINT, or PHYSICAL CAMERA NUMBER, and left or right to enable/disable the
selected option. These options are typically applicable only when LTC 8770 Series
Switcher Follower accessory devices are being used in the system.
Priority 1 users can use this function to select whether the biphase control data com-
mands will be addressed using the cameras' logical numbers or physical number
indexes in the Camera Table. Move the joystick up or down to select LOGICAL or
PHYSICAL and press [Enter] to activate your selection. If this option is set to LOGI-
CAL, AutoDome Series cameras and Allegiant Series receiver/drivers should be
addressed using the cameras' logical identification number. If it is set to PHYSICAL,
the devices should be addressed using the cameras' physical port number.
This function allows configuration of the system's PRINTER port for use with a
LTC 8712 Series Console Port Expander accessory device. Move the joystick up or
down to select the printer port function; NORMAL or EXPANDED. Press [Enter] to
activate your selection. Reset the system for this setting to take effect.
Use this function to select the switcher's interface port to be connected to an external
LTC 8016/90 Allegiant Bilinx Data Interface accessory unit. Move the joystick up or
down until the desired port for use as a data interface (DIU) is displayed. Press
[Enter] to configure the port. If using the LTC 8555 keyboard, press [User] to exit
the mode.
This function provides three (3) configuration options that determine the behavior
and content of the data commands issued by a master system to a satellite system. In
most cases, it is only necessary to change the default setting if using a multi-level cas-
Bosch Security Systems | December 13, 2005
Hide quick links:
Advertisement
Table of Contents
