Operating; Leds And Lcd Keypad - Bosch FMR-1000-RCMD Installation And Operation Manual

12 en | Operating
–
For front panel programming, the system provides an auto learn function, allowing the
installer to configure the system quickly and easily in default mode.
Using a local laptop or remote access through a communicator, the programming is carried
out by means of browser-based user interface (virtual keypad).
Refer to the FPA-1000 Installation and Operation Guide (P/N F.01U.173.607) for detailed
programming instructions.
9

Operating

9.1

LEDs and LCD Keypad

The LEDs on the Remote Command Center follow the global system status (refer to
Table 9.1). In addition, a communication fault on the Option Bus is indicated by the trouble
LED flashing at 1 Hz (refer to Section 10 Troubleshooting on Page 15).
Legend
1
2
3
4
5
LED
Fire
Red
Gas Alarm
Blue
Power
Green
Flashing
Supervisory
Yellow
Silenced
Yellow
F.01U.078.098 | 3.0 | 2011.11
Remote, using a Web page and an Ethernet connection.
LEDs
Device key
LCD screen
Scroll keys
Keys for Drill, Reset, Silenced,
and Acknowledge [ACK]
System Status
On Whenever the system registers a fire alarm and is not reset
Off – If no alarm registered
– After resetting
On When the system registers a gas alarm and is not reset
Off – If no gas alarm registered
– After resetting
On If AC power is applied to the panel
1) When AC power fails and the unit operates from battery power
Off When no power (AC or battery) is applied
On When the system registers a supervisory condition
Off When no supervisory condition is registered
On – When an alarm or trouble condition is silenced manually by the user
– If the system auto-silence timer expires
Off – When no condition is silenced
– When a silenced condition is corrected
Installation and Operation Guide
1
2
3
5
Figure 9.1 Front View FMR-1000-RA
Remote Command Center
1
4
5
Bosch Security Systems, Inc.