Before Operating; Before Operating Starting - Beko nstallation & operating instructions and washing guidance Operating Instructions Manual

4

Before operating

Starting
Final Check
Before you start using the refrigerator
check that:
1.The front feet have been adjusted
so the appliance is level.
2.The interior is dry and air can
circulate freely at the rear.
3.Clean the interior as recommended
under "CLEANING AND CARE."
4.Insert the plug into the wall socket
and switch on the electricity supply.
Avoid accidental disconnection by
taping over the switch. Green light will
glow and the compressor will start
running in about five minutes.
5.You will hear a noise as the
compressor starts up. The liquid and
gases sealed within the refrigeration
system may also give rise to noise,
whether the compressor is running or
not which is quite normal.
6.We recommend that you set the
thermostat halfway between Min. and
Max. (See section Temperature Control
and Adjustment).
7.Do not load the appliance
immediately it is switched on. Wait
until the correct storage temperature
has been reached. We recommend
that you check the temperature
with an accurate thermometer (see;
Temperature Control and Adjustment)
1.If there is a power failure do not open
the door. Frozen food should not be
affected if the failure lasts for less than
11 hours. If the failure is longer, then
the food should be checked and either
eaten immediately or cooked and
then re-frozen.
2.If you find the freezer door difficult
to open just after you have closed it,
don't worry. This is due to the pressure
difference which will equalise and
allow the door to open normally after a
few moments.
3.You will hear a vacuum sound just
after closing the door. This is quite
normal.
4. When you switch on, the appliance
will not start immediately, because the
appliance incorporates a protection
device in the electronics - wait for
about 5 minutes.
25
EN