Connections - JVC LT-24G20 Instructions Manual

Connections

Note: Before you connect other appliances:
• To avoid potentially damaging your set, make sure all items are switched off and disconnected from the
mains power when you make the connections.
• Arrange the desired connection.
• When you have finished making the connections, reconnect the mains power to the unit and switch it
back on.
Connect your antenna as shown below (A). Connections to other equipment is explained further on
P.21, 22. If you have problems with reception, consult a specialist of antenna.
Back Side
LT-24G20
(F)
(G)
(H)
(I)
M4 x 10
100 mm
(K)
LT-42G20
(D)
(I)
(H)
(B)
(D)
(M)
Woofer (LT-42G20)
(N)
Service connector cover: Please do not open this cover. There is a socket only for service purpose inside.
8
(N)
(N)
100 mm
(L)
(J)
(N)
(N) (A)
M6 x 10
(L)
200 mm
(J)
(G)
(C)
(B)
(F)
(A)
(B)
(C)
(D)
(E)
(M)
200 mm
(K)
(A) ANT input: Connect to an
analogue cable connection.
(B) AV1 input (LT-42G20:AV1/AV2
input): Input for analogue AV-
Signal (Composite) See P.21.
Note: AUDIO input of AV2 is
sharing with COMPONENT
AUDIO input.
(C) COMPONENT input: See P.22.
(D) HDMI/DVI input (LT-42G20:
HDMI1/DVI/HDMI2/3 input):
See P.20.
(E) HEADPHONE jack (LT-24G20):
Plug headphones with a mini
plug (3.5 mm) into this jack.
(F) AV Output: Output analogue
AV-Signal (Composite) See P.22.
(G) PC input: See P.19.
(H) AUDIO PC/DVI input: See P.19,
20.
(I) USB input: See P.15.
(J) To hang the television on a wall,
remove these screws and then
remove a stand.
Before performing work spread
cushioning over the base area to
lay the TV on.
(K) Power supply: Connect the
supplied power cable to an AC
110-240V/50/60Hz mains power
supply only - do not attempt
to connect it to any other type
of supply. Never try to repair a
damaged AC power cord with
isolation-tape - this should
be repaired by a specialist or
replaced. Do not let your pet
loose near the cable. Animals
biting into the cable could
receive a fatal electric shock,
and could cause a hazard to
others.
(L)
Bracket holes: To attach a wall
mounting bracket (not supplied),
remove the screw (LT-42G20),
then attach where indicated in the
drawing.