GE 55927740 User Manual page 9

4. Carefully turn the phone over. Detach the
mounting bracket from the two sets of top
grooves by pressing the tabs in. Pull the bracket
from the phone and turn it around so that it
looks like the diagram. Gently press the bracket
into the two sets of bottom grooves until it snaps
into place.
5. Plug the line cord into the jack on the back of the
base. Wrap the extra line cord, if any, around the
hooks provided on the bottom of the unit.
6. Feed the short line cord through the grooves
provided so that the bottom of the phone is flat and ready to mount on the wall.
7. Connect the other end of the line cord into the wall phone jack.
8. Connect the small end of the power adaptor into the POWER 7.5V AC jack on the
back of the answerer. Plug the other end into an AC power outlet. The unit beeps
once and is ready for setup or to answer calls with the default greeting and settings.
9. Slip the mounting holes of the base (on bottom of unit) over the wall plate posts
and slide the base down until the phone is firmly in place.
Important Instructions for Moving the Answerer:
To move the answerer to a different location in the house, follow these instructions:
1. Disconnect the phone line.
2. Go to the electrical outlet and unplug the power adaptor.
3. Move the unit and phone line to the desired location.
4. Plug in the power adaptor into an electrical outlet.
5. The display shows that the messages have not been erased.
6. Connect the phone line.
7. Reset the time/date settings or wait for the next call to set them automatically.