Installation - M-Audio StudioPro 4 User Manual

Installation

For optimal performance of the StudioPro 4, please read the following directions
carefully before installation.
Precautions
Handling: Please do not touch the speaker cones (the Woofer or the Tweeter); this
could damage the unit, affecting sound quality. The StudioPro 4 speakers are
packaged in the box tightly, so your attention is required when taking the speakers out
of the box. To avoid possible damage to the speakers, hold both sides of the unit (not
the front or the back) in order to pull it out of the box. To avoid damage, the speaker
cones should never be touched, even after they're out of the box.
Connections: Connect the StudioPro 4s RCA inputs to the corresponding computer
sound card or game console outputs. We recommend that you use high-quality cables
for input connections. Be sure that the StudioPro 4 is powered off before making any
connections.
If you need to connect the StudioPro 4 speakers to a device with 1/4-inch inputs, like
the M-Audio MobilePre USB, you can purchase an adapter cable that will have the 1/4-
inch connection on one end and the RCA connection on the other end.
Correct Power Operation: Since the StudioPro 4 contains amplifiers; it must be
connected to a power outlet using the detachable AC cable that is provided. Before
connecting power, please make sure that the power switch of the StudioPro 4 is in the
off position.
WARNING! - Use of improper Voltage may result in hazardous conditions
and/or damage to speaker components not covered by speaker warranty.
Speaker Wire Connections
Use the speaker wires included in the StudioPro 4 package to connect the Left and
Right Speakers via the spring terminals.
Connecting to a Computer Sound Card or Game Console
Before connecting the StudioPro 4s, make sure the power from the output device has
been turned off and the StudioPro 4 system is also turned off. Then plug the RCA cable
9
E
N
G
L
I
S
H