Epic A17u Bike User Manual page 10

11. Tip: It may be necessary to turn the
Adjustment Knob (27) and adjust the angle of
the Pivot Bracket (35).
Attach the Lower Pivot Cover (12) to the Pivot
Bracket (35) with two M4 x 12mm Screws (75).
Make sure that the indicated wire (A) is not
covered by the Lover Pivot Cover (12) (see
the drawing in step 12).
12. Tip: Avoid pinching the wires.
Orient the Upper Pivot Cover (9) as shown.
Press the Upper Pivot Cover onto the Lower
Pivot Cover (12).
Attach the Upper Pivot Cover (9) to the Console
(13) with an M4 x 15mm Screw (80).
13. Identify the Left and Right Upright Covers
(14, 15) and orient them as shown.
Have a second person hold the Right Upright
Cover (15) near the right side of the Upright (4)
Connect the wire on the Receiver (59) to the
wire (A) in the Upright.
Insert the excess wire into the Upright (4).
Tip: Avoid pinching the wires. Press the Left
and Right Upright Covers (14, 15) together
around the Upright (4).
11
75
35
A
12
80
9
12
A
13
4
14
10
27
12
Avoid pinching
the wires
13
15
59
A
Avoid pinching
the wires