Epic A17r Bike User Manual page 11

12. Locate the longest wire on the Console (13).
Insert that wire downward into the top of the
Upright (4) and pull it out of the indicated hole.
Connect the other two wires on the Console (13)
to the Main Wire Harness (58) and to the Pulse
Wire (64).
13. Identify the Lower Pivot Cover (12).
Tip: Avoid pinching the wires. It may be
necessary to turn the Console Knob (not
shown) and adjust the angle of the Console
Bracket (35).
Attach the Lower Pivot Cover (12) to the Console
Bracket (35) with two M4 x 12mm Screws (75).
Make sure that the indicated wire is not
covered by the Lower Pivot Cover (see the
drawing in step 14).
Next, press the Upper Pivot Cover (9) onto the
Lower Pivot Cover (12). Attach the Upper Pivot
Cover to the Console (13) with an M4 x 15mm
Screw (77).
14. Identify the Right Upright Cover (14), which has
the Receiver (59) attached.
Hold the Right Upright Cover (14) near the right
side of the Upright (4). Connect the wire on the
Receiver (59) to the indicated wire.
Tip: Avoid pinching the wires.
Next, press the Right Upright Cover (14) and
the Left Upright Cover (15) together around the
Upright (4).
12
13
4
Hole
64
13
9
77
35
Avoid
pinching
the wires
Wire
14
14
59
4
Wire
11
58
13
75
12
Avoid pinching
the wires
15