Fluke 725Ex User Manual page 23

No. Key
O
A
Turns the power on and off.
Selects voltage, mA, or loop power measurement functions in the upper display.
l
B
Clears the switch test. See "Switch Test".
Selects the pressure measurement function in the upper display. Repeated pushes cycle through
A
C
the different pressure units.
Use for pressure switch test. See "Switch Test".
K
D
Zeros the pressure module reading. This applies to both upper and lower displays.
C
E
Turns backlight on and off.
F F
Toggles between frequency and ohms measurement and sourcing functions.
D
G
Toggles between Centigrade and Fahrenheit when in TC or RTD functions.
Recalls a source value from memory corresponding to 100 % of span and sets it as the source
G
H
value. Press and hold to store the source value as the 100 % value.
I H
Increments output by 25 % of span.
I
J
Decrements output by 25 % of span.
Recalls a source value from memory corresponding to 0 % of span and sets it as the source value.
J
K
Press and hold to store the source value as the 0 % value.
Cycles through :
E Slow repeating 0 % - 100 % - 0 % ramp
L L
P Fast repeating 0 % - 100 % - 0 % ramp
N Repeating 0 % - 100 % - 0 % ramp in 25 % steps
Table 4. Key Functions
Description
Getting Acquainted with the Calibrator
13