Configuring Nokia Network Voyager Settings - Nokia NPS6113000 - Secure Access System Getting Started Manual

Installing the Nokia Secure Access System Gateway
Note
For information about how to configure the initial settings, see the IP series installation guide
that is included with your appliance.

Configuring Nokia Network Voyager Settings

After you complete the initial configuration, you can access the Nokia Network Voyager
configuration menu by using your Web browser.
Nokia Network Voyager is an SSL-capable, Web-based element management interface to Nokia
IP security platforms. Network Voyager is preinstalled on your appliance and is enabled through
the Nokia IPSO operating system. With Network Voyager, you can manage, monitor, and
configure the appliance from any authorized location within the network by using a Web
browser.
To access Nokia Network Voyager
1. Enter the URL of the appliance into your Web browser, by using either the appliance IP
address or hostname (for example, http://gateway.example.com).
2. When prompted, authenticate to Network Voyager with the username admin and the
password you specified during the initial configuration.
3. Configure the following appliance settings in Network Voyager:
a. Click the Local Time Setup link in the System Configuration section to set the local time
b. Set the default domain suffix, such as example.com.
c. Click the DNS link in the System Configuration section.
d. Specify a valid DNS server so that the gateway can resolve hostnames. The gateway
Click the DNS link in the System Configuration section.
14
IP address and netmask bit length for at least one network interface.
Set the netmask bit-length input to the number of bits in the network mask. For example,
for a network mask of 255.255.255.0, enter 24.
Default route address.
so that time stamps on logging messages are accurate.
Network Information System (NIS) client requires that DNS be configured to operate.
Nokia Secure Access System Getting Started Guide