Unit Installation - Boss Audio Systems BV7948B User Manual

1.8 UNIT INSTALLATION

INSTALLATION IN STRUC TIONS
THE UNIT INSTALLATION IS ANTI-THEFT ONE. THE UNIT CHASSIS WEARS A SLIDING METAL HOUSING.
FIRSTLY CONNECT THE POWER LINES, SPEAKER LINES AND AUTO ANTENNA ACCORDING TO MANUAL
REQUIREMENT, THEN INSTALL THE SLIDING METAL HOUSING IN A CAR ACCORDING TO THE DIAGRAM.
TO BOOST UP THE CAPABILITY OF
ANTI-JAMMING, PLE ASE FIX THE
METAL STRAP ON THE METAL
CONNECTED TO THE CHASSIS OF
METAL STRAP
THE CAR.
DASH BOARD
SLIDING METAL HOUSING
TO DRAW THE CHASSIS OUT OF THE
SLIDING METAL HOUSING, INSERT
THE LEFT AND RIGHT KEY PLATES
INTO THE TWO SIDES OF CHASSIS.
NOTE
REMOVE THE SLIDING METAL HOUSING
To demount the front panel
To mount the front panel
PDF created with FinePrint pdfFactory trial version
SELECT THE PROPER TABS
OF THE SLIDING METAL
HOU SING TO FIX THE
SLID ING METAL HOUSING.
UNIT CHASSIS
PLASTIC TRIM OUT
FRONT PANEL
REMOVE THE DECK TRANSPORT
SCREWS BEFORE INSTA LLING IT.
EJECT BUT TON
RE SET BUTTON
http://www.pdffactory.com
4.25.6 DIGITAL SETUP
OP MODE
It is for selecting audio output mode
DYNAMIC RANGE
After selecting the compression mode of LINE OUT, set the item, so you can
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
DUAL MONO
It is for selecting a desired audio output mode for the left and right ways of signal.
It is mainly for Karaoke of Ac3. There are 4 modes in all as follows:
STEREO, MONO L, MONO R, MIX MONO.