Behringer EUROCOM SPL3220 Quick Start Manual page 6

10
EUROCOM SPL3220
EUROCOM SPL3220 Controls
(1) (2) (3) (4)
2) (3) (4) (5) (6) (7) (8)
(11)
(5) (6) (7) (8) (9)
(9) (10)
(11)
(12)
11
Quick Start Guide
Step 2: Controls
(EN)
(10)
(12)
POWER switch turns the unit LIMITER knob sets the point
(1) (8)
on and off. by which the output signal
is not allowed to go beyond.
THRESHOLD knob determines
(2)
The HI and LO LEDs will
the level at which the signal
light to indicate activity by
will be reduced in dynamics.
either limiter.
LEVELER knob compensates for
(3)
METER button determines
(9)
varying levels in the program
whether the LEVEL meter
material in order to achieve a
displays the input or
consistent compression.
output level.
RATIO knob determines the
(4)
LEVEL meter displays either
(10)
ratio between the input and
the input or output level,
output levels for all signals
depending on the position of
exceeding the threshold point.
the METER button.
The control range can be
adjusted from 1:1 to 6:1. OUTPUT A and B send the
(11)
processed signal via XLR or
PROGRAM button optimizes
(5)
Euroblock connectors.
the crossover frequency of the
two bands for either music INPUT A and B accept signals
(12)
(500 Hz) or speech (2 kHz). to be processed via XLR, 1/4",
or Euroblock connectors.
GAIN REDUCTION meter
(6)
indicates the current gain
reduction for each band.
OUTPUT knob allows the
(7)
output signal to be increased
or decreased to compensate
for level loss due to the
compression or limiting.