Programming A Search Bank - AOR AR8600 Operating Manual

8-4 Programming a search bank

Each of the 40 search banks may be programmed with
different frequency limits, receive modes, step size etc as
listed in section 8-1-1 of this manual.
"SRCH-PROG" menu.
Use the main dial or
bank you wish to program or over write. (The
used to move through the menu).
HI Input the higher end frequency in MHz format
(don't push enter)
STEP Assuming that a receive mode other than "AUTO" was selected, you will be presented
with the "SET STEP" menu. Use the main dial or
from the following: 0.05 kHz (50 Hz), 0.1 kHz (100 Hz), 0.2 kHz (200 Hz), 0.5 kHz (500 Hz),
1.00 kHz, 2.00 kHz, 5.00 kHz, 6.25 kHz, 8.33 kHz, 9.00 kHz, 10.00 kHz, 12.50 kHz, 20 kHz,
25.00 kHz, 30 kHz, 50 kHz, 100.00 kHz. Alternatively a step size may be entered in kHz format
via the keypad in multiples of 50 Hz in the range of 50 Hz to 999.95 kHz (do not push enter).
to access the
keys or keypad to select the
LO Input the lower start
frequency in MHz format
(don't push enter)
MODE SET
receive mode, the
Note: If the receive mode is set to "AUTO", the receive mode,
channel step, step-adjust, frequency offset will be taken from the
pre-programmed auto band plan data, for this reason the
detailing will not be required while programming so is skipped...
the next menu will be TEXT INPUT.
key is
Use the keys or main dial to select
key is used as a short cut to "AUTO".
keys to select the required tuning step