Replacing/Installing Backup Batteries; Replacing And Installing Clock Backup Battery - iHome iBT20 Instruction Manual

Replacing and Installing Clock Backup Battery

Note: The CR2450 lithium battery is included in the unit. Please pull out the battery pull tab before you
use the unit.
This model is equipped with a battery backup circuit that will maintain the time and alarm time settings in
the event of a temporary power interruption (the display is NOT maintained). The battery backup circuit
will also operate the buzzer alarm to wake you up at the selected wake up time even if the power is out.
Note that Snooze function is disabled when operating on backup battery. The battery backup circuit
requires one CR2450 lithium battery, included.
When the backup battery is getting weak the Low Backup Battery Indicator will begin flashing in the
display. When you see this flashing indicator you should replace the backup battery as soon as possible.
Purchase a replacement CR2450 battery, available wherever batteries are sold, and follow steps 1 - 3
below to install the replacement battery.
To replace the backup battery:
IMPORTANT: When replacing the backup battery be sure to have the unit connected to the AC outlet to maintain
all of your settings, otherwise it will be necessary to reset the time and alarm time after the battery is replaced.
1. Remove battery cover located on the bottom of the unit and
remove the exhausted CR2450 battery.
2. Insert a fresh CR2450 battery in the backup battery compartment
with the "+" side facing up, as illustrated.
3. Replace the battery compartment cover Confirm that the backup
battery indicator is not flashing in the display.
Note: Make sure you dispose of battery properly (see your local regulations)
Battery Warning
• Do not heat above 75ºC (167ºF)
• Do not open batteries
• Do not dispose of in fire
Using the
• Do not expose contents to water
• Do not charge or recharge
• Do not install backwards
12
iBT20