Philips 50PFL4008G User Manual page 28

More sound settings
You can change the settings in the Sound
menu.
1. Press .
2. Select [Setup] > [TV settings] > [Sound],
then press OK.
3. Select a setting to change, then press OK.
x
[Sound style]: Access predefined sound
settings.
x
[Restore style]: Restore the
last-selected predefined sound setting.
x
[Bass]: Adjust the bass level of the
speaker and headphones.
x
[Treble]: Adjust the treble level of the
speaker and headphones.
x
[Surround mode]: Select a surround
sound mode to enhance your audio
experience.
x
[Auto incredible surround 3D]: Select
a surround sound mode to enhance
your audio experience in 3D mode. For
certain models.
x
[Headphone volume]: Adjust
headphone volume.
x
[Advanced]: Access advanced settings
to enhance your audio experience.
- [Auto volume leveling]: Enable the
reduction of sudden volume changes,
for example, when switching channels.
- [TV speakers]: Select the preferred
speakers to stream audio from the TV.
See Connect your TV > Set up
EasyLink devices > Select speaker
output (Page 44).
- [Clear sound]: Enhance sound quality.
- [Audio Out format]: Select the type
of audio output through the digital
audio output connector. Choose
between [Multichannel] and [Stereo].
- [Audio Out levelling]: Set the output
level for stereo audio. Select [Less] for
a certain amount of loss in intensity or
signal strength. Select [More] for no
loss in intensity or signal strength.
- [HDMI 1 - ARC]: Enable audio output
from the ARC-compliant device
connected to the HDMI 1 connector.
EN 28
- [Audio out delay]: Automatically sync
the image on the TV to the audio from
a connected home theater. You do not
need to use this setting when
connecting the TV to a Philips home
theater.
- [Audio out offset]: Adjust the setting
for audio output delay. Available if
[Audio out delay] is switched on.
Audio format
If an analog TV channel broadcaster streams
stereo audio in multiple formats, you can
select an audio format.
1. Press .
2. Select [Setup] > [Channel settings] >
[Mono/Stereo].
3. Select a setting, then press OK.
Reset picture and sound
You can restore the default picture and
sound settings, while the channel installation
settings remain the same.
1. While you watch TV, press
2. Select [Setup] > [TV settings] > [General
settings] > [Factory settings], then press
OK.
3. Select [Reset], then press OK.
All TV settings (except for channel settings)
are reset to the default factory settings.
.