Table of Contents
Advertisement
Trouble Shooting
Symptom
Windows does not recognize that the
Programmer has been connected to the
computer.
When preparing to transfer data, a
"No compatible device available." message
appears.
When preparing to transfer data, a "There
is no data card in the Programmer."
message appears.
"An unrecognized data card is in the
progammer." message appears when you
attempt to transfer data.
4
Trouble Shooting Guide
Probable Cause
USB Connector is not properly inserted
into the USB port on the computer.
USB Port on your computer is not
properly configured.
System operating software is not USB
compatible.
Programmer is not connected to USB port.
Card Programmer drivers are not installed.
No Data Card has been inserted in the
Programmer.
The Data Card is not fully inserted into the
Programmer.
The Data Card in the Programmer is
damaged
MapSource must be updated to be
compatible with the card.
Remedy
Be certain the Programmer has been
properly connected to your computer.
Consult your computer supplier.
Be certain the computer is operating on
Windows 98 or Windows 2000 software.
Reconnect the USB Connector to the computer
Install drivers.
Insert a Data Card into the Programmer.
Push the Data Card fully into the slot in
the Programmer. When properly inserted,
the card will protrude approximately 1/2
inch from the slot.
Insert a different card and try again.
Update MapSource software from the
GARMIN website.
Advertisement
Table of Contents
