Table of Contents
Advertisement
Grill
Lighting
Instructions
1. Before
each
use, check
all hoses
for cracks,
nicks,
cuts,
burns
or abrasions,
if a hose
is damaged
in any way,
do
not use your
grill before
replacing
the hose with
an
authorized
part from
the Parts
List. Also
make
sure all
gas
supply
connections
are
securely
tightened.
2. Familiarize
yourself
with
the safety
and Use and Care
instructions
in this manual.
Do not smoke
while
lighting
grill or checking
gas supply
connections.
3. Be sure
the LP Gas tank
is filled.
4. Open
the Grill Lid.
5. Check
that the end of each Burner
Tube
is properly
located
over each
Valve
Orifice.
Failure
to replace
a faulty
hose,
secure
gas
supply
connections
or
to open
the
Lid
before
proceeding
to
the
Lighting
Procedures
could
result
in
a fire
or
explosion
that
could
cause
serious
bodily
injury,
death,
or
property
damage.
6. Set Control
Knobs
to OFF and open
the LP Gas
tank
valve
SLOWLY
1/4 of a turn.
For Natural
Gas
open
the Shut Off Valve at source.
|
Open
LP
Gas
tank
_-"_
OFF
7. Push and turn one
Control
Knob to IGN
and hold it in
3-4 secs to ignite the Burner._Once
the burner
is lit,
turn the knob back to HIGH,
!
IGN
Low_
OFF
8. If ignition
does
not occur
in 5 seconds,
turn gas off at
source
and turn Control
Knobs
OFF. Wait at least 5
minutes
for gas to clear, then
retry.
If your grill still fails
to light turn the burner
Control
Knob(s)
and gas source
OFF and conduct
a leak test of ALL gas connections
and gas sources
as explained
in the Use and Care
section
of this manual,
if no leaks are detected,
wait
5
minutes
for any gas to clear
and repeat
the lighting
procedure.
9. After one Burner
is lit, turn the tank valve SLOWLY
one
more 1/4 of a turn for 1/2 of one complete
turn.
10. Repeat
steps
to light each
burner
individually. Turn
Knob
for each other
burner
and light as you move
toward
the fuel source.
Burner
Control
Knobs
on Control
Panel
Main Burner
Back
Infrared
Burner
Burner
16
Back
Burner
Lighting
Instructions
1. Follow
steps
1 through
6 of the Grill Lighting
instructions.
2. Push and turn the Control
Knob
to IGN and hold it in
3-4 seconds
to ignite the Burner.
3. Keep
pressing
and turning
knob
to HIGH
and hold in
5-10
seconds
before
releasing.
4. if ignition does
not occur
in 5 seconds,
turn gas off
at source
and turn Control
Knobs
OFF. Wait at least
5 minutes
for gas to clear,
then retry.
If your grill still
fails to light turn the Control
Knob(s)
and gas
source
OFF and conduct
a leak test as explained
in
the Use and Care section
of this manual.
If no
leaks are detected,
wait 5 minutes
for any gas to
clear and repeat
the lighting
procedure.
5.
After Burner
is lit, turn the tank valve SLOWLY
one
more 1/4 of a turn for 1/2 of one complete
turn.
IMPORTANT:
Do not use the Back
Burner
and Main
Burners
at the same
time.
Backburner
is for Rotisserie
Cooking
only.
BACK BURNER
KNOB:
!
IGN
OFF
Infrared Burner Lighting
1.
2.
3.
4.
INFRARED BURNER
KNOB:
|
IGN
Low_
OFF
Instructions
Follow
steps
1 through
6 of the Grill Lighting
instructions.
Push and turn the Control
Knob
to IGN and hold it in
3-4 secs
to ignite the Burner.
Keep pressing
and turning
knob
to HIGH and hold in
5-10
seconds
before
releasing.
if ignition does
not occur
in 5 seconds,
turn the
burner
Control
Knob(s)
and gas source
OFF
and
conduct
a leak test as explained
in the Use and
Care
section
of this manual.
If no leaks
are de-
tected,
wait 5 minutes
for any gas to clear and
repeat
the lighting
procedure.
5. After Burner
is lit, turn the tank valve SLOWLY
one
more
1/4 of a turn for 1/2 of one complete
turn.
Side
Burner
Lighting
Instructions
1. Follow
steps
1 through
5 of the Grill Lighting
Instructions.
2. Open
Side
Burner
Lid.
3. Set Control
Knobs
to OFF and open
the LP Gas
tank
valve SLOWLY
1/4 of a turn.
4. Push
and turn control
knob to HIGH ._
5. You may have to push and turn the Control
Knob
up
to 3 or 4 times to light.
6. If ignition
does
not occur,
turn gas off at source
and
turn Control
Knobs
OFF. Wait
at least 5 minutes
for
gas to clear, then
retry, if your grill still fails to light
turn
the burner
Control
Knob
and gas
source
OFF
and
conduct
a leak test of ALL gas connections
and fuel
sources.
If no leaks are detected,
wait
5 minutes
for
any gas to clear
and repeat
the lighting
procedure.
Manually Lighting
Your
Grill
By Paper
Match
To light your gas grill by match,
insert a match
into the
Lighting
Stick and follow
steps
1 through
6 of the Grill
Lighting
Instructions.
Then,
light the match
and place
(continue
over
page)
Advertisement
Table of Contents
