Install The Range - GE PB970 Installation Instructions Manual

JnstaJJation instructions
INSTALL THE RANGE
[] REPLACE THE WIRE COVER
Replace the terminal block cover on the
range back by replacing the screw removed
earlier. Make sure that no wires are pinched
between the cover and the range back.
Screw to
replace
terminal
block cover
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with
instructions for installation in a variety of
locations. The instructions include all
necessary information to complete the
installation. Read the Safety Instructions
and the instructions that fit your situation
before beginning installation.
Bracket... Wall plate
enter wood
_Lt_'_ ....._°, ---__
Typical installation of anti-tip bracket attachment to wall
-4, WARNING:
• Range must be secured by Anti-Tip bracket
supplied.
• See instructions to install (supplied with bracket).
• Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids
or from the range itself.
PREPARE TO LEVEL MODELS
[] Measure the height of your countertop
at the rear of the opening (X).
X
[] Adjust two rear leveling legs so that the
rear of the cooktop (Y) is at the same
height as the counter (X).
[] Slide unit into place.
8