Toshiba M105-S1021 - Satellite - Celeron M 1.46 GHz User Manual page 146

Installing Memory on Bottom Side
If you use the computer for a long time, the memory modules will become
hot. In this case, let the memory modules cool to room temperature before
you replace them.
Follow these steps to install a memory module:
1. Set the computer to boot mode and turn off the power.
Do not try to install a memory module under the following conditions. You
can damage the computer and the module.
a. The computer is turned on.
b. The computer was shut down using the Stand by mode.
c. Power to the optical disc drive has been turned on by the CD Power
2. Remove all cables connected to the computer.
3. Turn the computer upside down and remove the battery, refer to Chapter
6, Power and Power-Up Modes.
4. Loosen the one screw securing the memory module socket cover.
5. Slide your fingernail or a thin object under the cover and lift it off.
6. Fit the module's connectors into the computer's connectors at about a
45 degree angle and press the module carefully to ensure a firm
connection.
Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
7. Push the module down so it lies flat. Latches on either side will click into
place to secure the module.
8-8
switch.
Removing the memory module socket cover
Optional Devices
Satellite M100