Index Of Error Messages - eMachines D620 Service Manual

Index of Error Messages

Error Message List
Error Messages
Stuck Key
System CMOS checksum bad - Default
configuration used
Real time clock error
Previous boot incomplete - Default
configuration used
Invalid System Configuration Data
Operating system not found
Power-on indicator turns off and LCD is
blank.
Power-on indicator turns on and LCD
is blank.
Power-on indicator turns on and LCD
is blank. But you can see POST on an
external CRT.
Power-on indicator turns on and a
blinking cursor shown on LCD during
POST.
Failure Fixed Disk
92
Check or do the following in sequence:
See "Keyboard or Auxiliary Input Device Check" on page 88.
RTC battery.
•
Run the BIOS Setup Utility to reconfigure the system time,
•
then reboot system.
RTC battery
•
Run the BIOS Setup Utility to reconfigure system time, then
•
reboot system.
Mainboard
•
Run "Load Setup Defaults" in BIOS Setup Utility.
•
RTC battery
•
Mainboard
•
Run "Load Setup Defaults" in BIOS Setup Utility.
•
Mainboard
•
Run the BIOS Setup Utility to check if the fixed disk and drive
•
A are properly identified.
CD/DVD-ROM drive
•
Hard disk drive
•
Mainboard
•
Power source (battery pack and power adapter.) See "Power
•
System Check" on page 89.
Ensure every connector is connected tightly and correctly.
•
Reconnect the DIMM
•
Mainboard
•
Power source (battery pack and power adapter.) See "Power
•
System Check" on page 89.
Reconnect the LCD connector
•
Hard disk drive
•
LCD cable
•
LCD inverter
•
LCD
•
Mainboard
•
Reconnect the LCD connectors.
•
LCD cable
•
LCD inverter
•
LCD
•
Mainboard
•
Ensure every connector is connected tightly and correctly.
•
Mainboard
•
Reconnect the hard disk drive connector.
•
Run "Load Setup Defaults" in BIOS Setup Utility.
•
Hard disk drive
•
Mainboard
•
Chapter 4