NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Remove any installed PC Cards from the PC Card slot.
8. Remove any installed Secure Digital memory card from the Secure Digital memory slot.
9. Close the display and turn the computer upside down on a flat work surface.
NOTICE:
To avoid damaging the system board, you must remove the main battery before you service the computer.
10. Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the bay.
1
battery latch release (2)
11. Remove any installed modules, including a second battery, if installed.
12. Remove the
hard
drive.
Computer Orientation
1
front
2
left
3
back
4
right