Table of Contents
Advertisement
Start-up and use
! The first time you use your appliance, heat the empty oven
with its door closed at its maximum temperature for at least
half an hour. Make sure that the room is well ventilated
before switching the oven off and opening the oven door.
The appliance may emit a slightly unpleasant odour caused
by protective substances used during the manufacturing
process burning away.
! Turn the control dial to adjust the parameter shown on the
display between the "<" and ">" symbols.
! To make the setting process easier, keep the control dial
in position: this will increase the scrolling speed of the
numbers on the display.
! Each setting will automatically be stored in the appliance
memory after 10 seconds.
! The touch controls cannot be activated if the user is
wearing gloves.
Some models are equipped with a system of hinges which
allows the door to close slowly, without the user having to
follow the movement through with his/her hand. To use the
system correctly, before closing the door:
• Open the door fully.
• Do not force the closing movement manually.
Switching the oven on for the first time
After connecting the oven to the electricity supply, the
first time it is switched on the user should also switch on
the control panel by pressing the
languages will appear in the menu. To choose the desired
language, select it using the control dial. Confirm by
pressing the
icon.
Once the selection has been made, the display will show
the settings menu. Press the
using the control dial until you reach the EXIT command
and press the
icon to begin using the oven.
! After choosing the language in the menu, if the display is
not used for another 30 seconds it will automatically revert
to programming mode.
Setings menu commands
To enter the settings menu, switch on the control panel and
press the
icon.
Use the control dial to highlight the individual menu
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
! When inserting the shelf
make sure the backstop is
at the rear of the cavity (see
image).
button. The list of
icon or scroll through
commands.
To modify the setting, press the
The following parameters are listed in the menu:
LANGUAGE: select the language shown on the display.
CLOCK: set the exact time.
TONE: activate/deactivate keypad tone.
LIGHT: activate/deactivate the internal oven light during
cooking.
LOGO: activate/deactivate logo on start-up.
GUIDE: activate/deactivate operating tips.
EXIT: exit the menu.
! It is possible to exit the settings menu by pressing the
icon.
Control panel lock
! The control panel can be locked while the oven is off, once
cooking has started or finished and during programming.
The control panel lock can be used to lock the controls.
To activate it, press the
command by pressing the control dial:
• NO LOCK: deactivate an active lock;
• BUTTONS: lock the controls;
Confirm by pressing the
A confirmation buzzer will sound and the
on the display.
The lock may be activated while the oven is in use, or while
it is switched off. It can also be deactivated in all the above
situations and after the oven has finished cooking.
Setting the clock
To set the clock, switch on the oven by pressing the
then press
and follow the steps described.
1. Scroll through the menu commands using the control
dial, select CLOCK and press
2. Adjust the time using the control dial.
3. Once you have reached the correct hour value, press
the
icon.
4. Repeat steps 2 and 3 to set the minutes.
5. To exit adjustment mode, press the
control dial to scroll through the menu until you reach EXIT,
then press
.
! The clock can also be set while the oven is off, by pressing
the
icon and carrying out steps 2 to 4 as described
above.
After the appliance has been connected to the mains, or
after a blackout, the clock will need to be reset.
Setting the minute minder
! The minute minder may be set regardless of whether the
oven is switched on or off. It does not switch the oven on
or off.
When the set time has elapsed, the minute minder emits a
buzzer that will automatically stop after 30 seconds or when
icon.
icon and select the desired
icon.
icon will appear
icon,
.
icon or use the
GB
7
Advertisement
Table of Contents
