Troubleshooting - Bosch WTE86300US/03 Operating & Installation Instruction

Troubleshootin
RISK OF ELECTRICAL SHOCK !
EXPLOSION HAZARD!
Repairs or replacement of parts
may be carried out by authorized
technicians only.
Before calling the customer service,
check whether you can rectify the
fault yourself by means of the
following table.
If a fault cannot be rectified or
a repair is required:
1. Set program selector to "Off".
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Call customer service
(see page 22).
Problem
Dryerdoesnotstart.
"Start/Stop"indicatorlight doesnot
illuminate.
Programhasbeen interrupted."Filter"
indicatorlight illuminates, a warning
signalis emittedandthe display shows
"F:01" or "F:02".
Drumlight doesnotfunction.
"Start/Stop"indicatorlight doesnot
illuminate."WrinkleblocWFinished"
indicatorlights.
Thedisplayshows" 0-".
Possiblecause
Mainplug not inserted at all or notinsertedcorrectly.
A fuse of powersupplyhastripped.
"Start/Stop"buttonnot pressed.
Doornot closed.
Ambienttemperaturebelow41 °F/5 °C.
Lintfilter dirty.
Faultin programsequence or malfunction.
The room/cabinet i s not adequately ventilated.
Noprogramselected.
Lightbulbdefective,lightbulbburnedout.
Nopowersupply.
Faultin programsequence or malfunction.
Moisturesensordirty.
Remedialaction
Insertmainplug correctly,
Replace/switch o n fuse,
Press"Start/Stop"button,
Closedoor,
Increaseroomtemperature,
Cleanfilter as described on page 19,
Switchoff/switchon again,
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again,Restart p rogram,
Providean adequatesupplyof fresh air,
Switchoff/switchon again,
Selectprogram,
Changelight bulb,seepage20,
Guarantee powersupply,
Switchoff dryer,leaveto cooldownfor 30 min,
switchon again,Restart p rogram,
Cleanmoisturesensoras described on page20.
Switchoff/switchon again.
"Start/Stop"indicatorlight flashesand Condensation o utlet. Checkhosefor condensation o utlet.
the displayshows"F:03".
Laundrywastoo wet.
Unsuitable programselected.
Maximumdryingtime was exceeded.
Degree of dryinghasnot beenreached
or the dryingtime istoo long.
Displaymay indicate"F:04".
Motor limittemperaturewas exceeded.
Spin laundryat higherspeedin the washing
machine.Switchoff/switchon again.
Selectprogramwith aid of the programselection
table(seepage 26).Switchoff/switchon again.
Cleanlintfilter (seepage 19).
Checkhosefor condensation o utlet.
Spin laundryat a higherspeedin yourwasher.
Switchoff dryer,leaveto cooldownfor 30 min.
Switchon again.Start program.
21