Table of Contents
Advertisement
Installation
-
step by step
1. Unpack the dryer.
2. Remove all objects from the
drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation
location.
5. Have the power supply cord
fitted by an authorized
technician
(see page 8).
6. Move the dryer to its final
location
and align.
Do not slide dryer across the
floor if height-adjustable
feet
have been extended.
Feet and/or
dryer base may be damaged
if
dryer is slid across floor with
height-adjustable
feet extended.
7. Position and then level the
dryer.
The dryer should be level with
all four feet firmly on the
ground. The dryer must not
wobble.
If the dryer is not level or if it
does wobble, the feet must be
adjusted.
Adjust the
height-adjustable
feet until the
dryer does not rock and is level,
both front-to-back
and
side-to-side.
8. Insert plug into the wall
receptacle.
Built under
Installation
The appliance can be built
under; that is, you can instaii the
dryer under-counter
in a kitchen
cabinet opening. The cabinet
opening should be square and
have dimensions
as shown in the
figure.
a
b
C
600 mm minimum//23
5/8"
600 mm minimum//23
5/8"
850 mm minimum//33
1/2"
If installed under a countertop,
the countertop
must be
continuous
and securely
attached
to neighboring
cabinets.
An opening of at least 31 square
inches (200
cm 2)
must be avail-
able at the front and side of the
closet.
Check
list before
using the dryer
1. Check that steps 1-8 have
been implemented
properly.
2. Ensure that the dryer is
connected
to the power supply.
3. Read the operating
instructions
to understand
how your dryer
operates.
4. Conduct
an appliance
test:
13 Check that the drum is
empty.
13 Close the dryer door.
13 Switch the dryer to "Extra
Dry" and then press the
Start button.
13 After 3-5 minutes
press the
Stop button and open the
door.
5.
6.
If the interior of the dryer feels
warm, the dryer has been
connected
properly.
Switch the dryer to "OFF".
If the dryer does not work,
switch the dryer to "OFF".
Look in the troubleshooting
section (page 21) of the
OPERATING
INSTRUCTIONS
and find the fault.
Preparing
to transport
the dryer-
step
by step
1. Rotate the program
selector
to "OFF".
2. Pull out power supply plug.
3. Place any accessories
in the
drum.
.
.
Close the door and secure with
adhesive tape.
Screw the height-adjustable
feet of the dryer into the
housing to prevent them from
being damaged
during
transportation.
11
Hide quick links:
Advertisement
Table of Contents
