Garmin Mobile 10 Set Up And Go Manual page 6

Bluetooth LED Status
• Rapid Flashing Blue: power on, Bluetooth on
• Slow Flashing Blue: Bluetooth link to your mobile
device established
Power LED Status
• Flashing Yellow Green: charging in progress
• Solid Yellow Green: battery is charged
• Flashing Orange: low battery
• Solid Orange: faulty battery or system error
More Information on the Bluetooth
Wireless Connection
• Make sure the GPS 10x is turned on.
• If nRoute cannot find your GPS 10x, select
Utilities > Select GPS, and click AutoDetect.
• Make sure the Bluetooth software on your mobile
device is properly configured. nRoute connects to
your GPS 10x using a COM port.
• The GPS 10x receiver PIN/passkey is 1234.
• See www.garmin.com/support/faqs. Enter
"Bluetooth" and click Search.

Install the GPS 10x in a Vehicle
➎
To communicate using Bluetooth
the GPS 10x receiver must be within approximately 30
feet (10 meters) of the mobile device.
To receive satellite signals, place the GPS 10x receiver
where it has a clear view of the sky.
Acquire GPS Signals
➏
Open the navigation software (nRoute or Garmin
Mobile XT) on your mobile device. Check that the
®
Blue LED on the GPS 10x receiver is slowly flashing
blue, indicating a wireless connection. Go outdoors
to an open area, away from tall buildings and trees.
Acquiring satellite signals may take a few minutes.
When the Infobar in nRoute displays Ready to
Navigate, your GPS 10x receiver has acquired satellite
signals. When the
Garmin Mobile XT are green, your GPS 10x receiver
has acquired satellite signals.
wireless technology,
®
bars in the upper-left corner of
Garmin Mobile 10 set up and go!
™