Kenmore 116.25614 Owner's Manual page 18

TO REPLACE BELT
t_lnstatlnew
belt over
_es over
belt pu _ey_
NOTE_ See
PARTS AND
End Cap
2_ Place ag tator
assemby back nto
3. Line up
front of
cover and
base. Rest
cover o_
fl_snt edge
of base as
showi%
Side
£a_ch
e_ve¢ BaS¢,_
_ 4 Rotate :over
[_}% back, Press
_ii over frmly uafi
sde ard rear
latches snal}
Rear into pace
Latches
Make sure t_ere s no gap between the
cove and base_
5 R,lm Power Mate ups de dow_"_and
re@ace two (2} cove_ screws
1_ Remove Power*Mate ® cover as shown r_
BELT CHANGING AND AG_ R
CLBAMNG sect on.
2o Push n and tun
b@b countercbck_
wee, thes p@/out
to remove.
3 Push in and t,_rn
buib cbckwse to
repace Bub must
not be higher than
15 Wal_s('130 Volts}
4_ R@nsta/I Powe Mate ® cover as shown n
BELT CHANGING AND AGITATOR
CLEAMNG sect on
NOTE: See PARTS AND FEATURES for
bulb I_umber_
18