Initialize Error Log - Lexmark 7200 Color Jetprinter Service Manual

4092

Initialize Error Log

This test lets you track new errors.
Use this procedure to reset the error log to zero. The error log is
especially helpful in diagnosing intermittent or difficult problems.
To run the test:
1. Turn the printer off and place a two pin jumper on connector J6
as shown below. (Pins 3 & 4).
2. Place a sheet of paper in the manual feed far enough to activate
the EOF (End of Forms) sensor.
3. Press the Power Button. When the Power Light begins to flash,
the Error Log clear is complete. (This may take several
seconds). To stop the test, turn power off or unplug the printer.
Diagnostic Aids 3-3