Kenmore Electronic three-speed automatic washers Owner's Manual And Installation Instructions page 28

AUTOMATIC TEMPERATURE
CONTROL (ATC)
ATC takes away the worry
of undissolved detergent and
ensures consistent cleaning
results from season to season
with warm and cold washes.
ATC electronically senses and maintains
a uniform water temperature by regulating
incoming hot and cold water.
• Even in cold wash, some warm water
is let into the washer to maintain a
temperature of approximately 75°E
In very cold water, detergent may not
dissolve and clothes will not be cleaned
completely.
• ATC does not control the hot wash
water temperature.
• Warm wash is regulated at approximately
100°E
• Warm rinse is regulated at approximately
75°F for all warm rinses. This may be
a cooler warm rinse than what you are
used to, but it saves energy and still
gives you proper rinsing and a load
that is comfortable to remove.
• The second fill in the PERMANENT
PRESS Cycle is for cooling the load
and uses unregulated cold water.
ATC can be turned on and off by
pressing the pad for AUTO TEMP next
to the TEMPERATURE display.
ADJUSTABLE CYCLIE SIGNAL
A tone will sound at the end of the wash
cycle. The sound level of this tone can
be adjusted from loud to off by pressing
MORE or LI-SS under the CYCLE
SIGNAL displ_Ly. The tone you will hear
at the end of the cycle will sound as the
pads are pr,es,,;ed.
I^ I ,,ss31
TEMPERATURE
28