Recommendations Table; Sewing In Zippers - Pfaff fashion Owner's Manual

Explanation of the sewing recommendations table
In the following table you will nd the settings we
recommend for different sewing purposes.
These tables give you further information required for
sewing the selected stitches – whether you should sew with
the Integrated Dual Feed (IDT) engaged or disengaged,
needle thread tension setting and recommended presser
foot,.
Stitch
Stitch Stitch number
Stitch width in mm
Stitch length in mm
IDT
Needle thread tension
Number of presser foot
Stitch
1 2.5
Straight stitch
Stitch 1 is the basic straight stitch in center needle position.
The stitch length can be increased up to 6 mm. Change the
needle position of the straight stitch to sew in a zipper or
topstitch along the edge of a collar. The expression 2028
have 13 needle positions that can be adjusted with the -/+
button A.
Stitch
1 3

Sewing in zippers

There are different ways to sew in zippers. Follow the
directions included with your pattern for best results.
For all types of zippers it is important to sew close to the teeth
of the zipper. The zipper foot can be snapped to the presser
foot ankle on the left or right, depending on how you will insert
your zipper. Then set the needle position so that it enters close
to the edge of the zipper teeth by using one of the 13 needle
positions available. If the presser foot is attached on the right
side, the needle must only be moved to the right. If the foot is
attached on the left, the needle must only be moved to the left.
Sewing
switched on
switched off
3-5 0
3-5 4
3:6