Indoor Unit Installation - Daikin FTXS15LVJU Installation Manual

Indoor Unit Installation

1.
Installing the mounting plate
• The mounting plate should be installed on a wall which can support the weight of the indoor unit.
1) Temporarily secure the mounting plate to the wall, make sure that the plate is completely level, and mark the boring
points on the wall.
2) Secure the mounting plate to the wall with screws.
Recommended mounting plate retention spots and dimensions
Through-the-wall
hole ϕ3-1/8 (ϕ80)
4-11/16
(119)
ϕ3-1/8
(ϕ80)
2-9/16 5-7/8
(65) (149)
Drain hose position
* The removed pipe port cover can be
kept in the mounting plate pocket.
2.
Boring a wall hole and installing wall embedded pipe
• For walls containing metal frame or metal board, be sure to use a wall
embedded pipe and wall cover in the feed-through hole to prevent possible
heat, electrical shock, or fire.
• Be sure to caulk the gaps around the pipes with caulking material to prevent
water leakage.
1) Bore a feed-through hole of 3-1/8 inch (80mm) in the wall so it has a
down slope toward the outside.
2) Insert a wall pipe into the hole.
3) Insert a wall cover into wall pipe.
4) After completing refrigerant piping, wiring, and drain piping, caulk pipe
hole gap with putty.
■
English
Recommended mounting plate retention
spots (9 spots in all)
Place a leveler on raised tab.
(Bolt size : 3/8 (M10))
15-1/4 2-9/16
(388) (65)
41-5/16 (1050)
Keep here the piece cut out
from the unit for piping
(Bolt size : 3/8 (M10))
5-1/4 (134)
ϕ3-1/8
(ϕ80)
3-1/2
7-3/16 (182.5) (89)
Gas pipe end
Liquid pipe end
Removed pipe
port cover
A
Mounting plate
Wall embedded pipe
(field supply)
Use tape
measure
as shown.
Position the
end of tape
∆
measure at
unit : inch (mm)
Inside Outside
Caulking
Wall hole cover
(field supply)
Wall embedded pipe
(field supply)
7