Preparation Before Operation; Remote Controller - Daikin FTKD50JVET Operation Manual

Preparation Before Operation

Remote controller

■ ■ ■ ■ ■ Setting the batteries
Position + and
Address switch
1
1
Press with a finger and slide the back
cover to take it off.
2
Set two dry batteries (AAA).
3
Set the back cover as before.
● This will cause the figures on the display
to flash. Set the clock at this point.
ATTENTION
About batteries
● When replacing the batteries, use
batteries of the same type, and replace
the two old batteries together.
● When the system is not used for a long
time, take the batteries out.
● When the operation display screen of the
remote controller is hard to see and the
reception become hard, replace the
batteries with new AAA batteries.
● The attached batteries are provided for the
initial use of the system.
The usable period of the batteries may be
short depending on the manufactured date
of the air conditioner.
8
– correctly!
2
3
■ ■ ■ ■ ■ Operating the remote controller
● To use the remote controller, aim the transmitter at
the indoor unit. If there is anything to block signals
between the unit and the remote controller, such as
a curtain, the unit will not operate.
● Do not drop the remote controller. Do not get it wet.
● The maximum distance for communication is about
7 m.
■ ■ ■ ■ ■ To fix the remote controller
holder on the wall
1
Choose a place from where the signals reach
the unit.
2
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
3
Fit the claw of the holder into the bottom of
the remote controller, and push the remote
controller onto the wall.
2 Push.
1 Set.
● To remove, pull it upwards.
ATTENTION
About the remote controller
● Never expose the remote controller to
direct sunlight.
● Dust on the signal transmitter or receiver
will reduce the sensitivity. Wipe off dust
with soft cloth.
● Signal communication may be disabled if
an electronic-starter-type fluorescent lamp
(such as inverter-type lamps) is in the
room. Consult the shop if that is the case.
● If the remote control signals happen to
operate another appliance, move that
appliance to somewhere else, or consult
the shop.
Receiver
Remote controller
holder